Elatec provides Configuration Cards which can hold a specific firmware image and can be placed on a reader and the image can be programmed in just a few seconds.
HID iClass Seos are not compatible with TWN4 Legic NFC, and must use reader TWN4 MultiTech - PIUse Elatec's Configuration Cards
Click here to learn more about the twn4-configuration kit1. In Elatec's Black & White reader with a kit (Reader + a couple Desire config cards) or a pre-programmed configuration card with a firmware image
2. Firmware on reader must Accept Configuration Cards which is set on the firmware when it is created
3. Config card must be presented directly on top of the reader until the program is complete
When the card is on the reader, it will beep once, then followed by low-high-low beep sounds.
The PrinterSDK_Evolis can be used to bring configuration card over reader and ejected.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article