Load Cards
1. Open the input hopper cover
2. Move the lever on the left side of the input hopper up or down to match the thickness of the cards
Default value on the input hopper 0.8
If the incorrect thickness is selected, an error will occur during card printing. Ensure to adjust the control level to the correct card thickness before moving on.3. Fan out the cards to prevent them from sticking together
4. Stack the cards vertically, then place them back in input hopper
5. Close the hopper cover
6. When loading a single card, feed it horizontal through the front card slot with the blank side up
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article